EPL service provides one Ethernet Virtual Connection (EVC) between two customer locations. EPL offers three Classes of Service (CoS) including: Basic, Priority, and Premium. CoS options enable customers to select the CoS that best meets their applications’ performance requirements. EPL service is offered with 10Mbps, 100Mbps, 1Gbps or 10Gbps Ethernet User-to-Network Interfaces (UNI) and is available in speed increments from 1Mbps to 10Gbps.
Comcast’s Ethernet Private Line Service is Certified MEF Compliant.
Section 1 - Technical Specifications
The service provides bidirectional, full duplex transmission of Ethernet frames using a standard IEEE 802.3 Ethernet interface (UNI). Figure 1 lists the available UNI physical interfaces, their associated Committed Information Rate (CIR) bandwidth increments and the Committed Burst Sizes (CBS).
Figure 1: Available UNI Interface Types and CBS values for different CIR Increments
|UNI Physical Interface||10BaseT||100BaseT||1000BaseT or 1000BaseSX||10GBASE-SR or 10GBASE-LR|
1.2 Class of Service Option
The service offers three different classes of service. The CoS options allow for differentiated service performance levels for different types of network traffic. It is used to prioritize customer mission-critical traffic from lesser priority traffic in the network. The customer must specify a CIR for each CoS to indicate how much bandwidth should be assigned to each CoS. Figure 2 lists the service performance objectives for each CoS for distances within 250 network miles.
Figure 2: Class of Services Performance Objectives
|Performance Objective (≤ 250 miles)||Premium||Priority||Basic|
|Latency (one way)||< 12ms||< 23ms||< 45ms|
|Jitter (one way)||< 2ms||< 23ms||< 45ms|
|Packet Loss (one way)||< 0.001%||< 0.01%||< 1%|
|Availability||> 99.99%||> 99.99%||> 99.99%|
1.3 CoS Identification and Marking
Customer must mark all packets using 802.1p CoS values as specified in Figure 3 to ensure the service will provide the intended CoS performance objectives specified in Figure 2.
1.4 Traffic Management
Comcast’s network traffic-policing policies restrict traffic flows to the subscribed CIR for each service class. If the customer- transmitted bandwidth rate for any CoS exceeds the subscription rate (CIR) and burst size (CBS), Comcast will discard the non-conformant packets. For packets marked with a non-conformant CoS marking, the service will transmit them using the Basic service class without altering the customer’s CoS markings.
1.5 Maximum Frame Size
The service supports a Maximum Transmission Unit (MTU) packet size of 1600 bytes to support untagged or 802.1Q tagged packet sizes. Jumbo Frame sizes can be supported on an Individual Case Basis (ICB).
1.6 VLAN Tag Preservation
The service supports IEEE 802.1Q VLAN-tagged customer packets. All customer VLAN IDs and priority code points (IEEE 802.1p) for CoS are transmitted and received unaltered by the service. Untagged packets are mapped to the native VLAN specified by customer. Customers may configure their own VLANs on their customer owned CPE without coordination with Comcast. Comcast may reserve one VLAN for network management purposes.
1.7 Ethernet Service Frame Disposition
The service delivers all service frames associated with the EVC unconditionally across the network as specified in Figure 4.
Figure 4: Service Frame Delivery Disposition
|Service Frame Type||Unicast||Multicast||Broadcast|
|Service Frame Delivery||Frames delivered conditionally||Frames delivered conditionally||Frames delivered conditionally|
1.8 Layer 2 Control Protocol (L2CP) Processing
Certain L2CP frames are discarded at the UNI, tunneled across the Comcast network or peered at (processed by) the UNI. Refer to Figure 5 for Comcast’s L2CP disposition. For L2CPs with multiple disposition possibilities, the customer must specify to Comcast which disposition should be taken. The default disposition is to discard these L2CP service frames.
Figure 5: L2CP Frame Disposition
|Destination MAC Address||Layer 2 Control Protocol||L2CP Frame Disposition|
|01-80-C2-00-00-00||STP, RSTP, MSTP||Discard (All UNIs)|
|01-80-C2-00-00-01||PAUSE||Discard (All UNIs)|
|01-80-C2-00-00-02||LACP, LAMP||Peer or Discard (disposition specified per UNI)|
|01-80-C2-00-00-02||Link OAM||Peer or Discard (disposition specified per UNI)|
|01-80-C2-00-00-03||802.1X||Discard (All UNIs)|
|01-80-C2-00-00-07||E-LMI||Discard (All UNIs)|
|01-80-C2-00-00-0E||LLDP||Discard (All UNIs)|
|01-80-C2-00-00-20 through 01-80-C2-00-00-2F||GARP, MRP||Tunnel (All UNIs)|
Section 2 - Monitoring Technical Support and Maintenance
Comcast monitors all Comcast Services purchased by a customer on a 24x7x365 basis.
2.2 Technical Support
Comcast provides customers a toll-free trouble reporting telephone number to the customer Business Services Network Operations Center (BNOC) that operates on a 24x7x365 basis. Comcast provides technical support for service-related inquiries. Technical support will not offer consulting or advice on issues relating to CPE not provided by Comcast.
Reported troubles are escalated within the Comcast BNOC to meet the standard restoration interval described in the Service Level Objectives. Troubles are escalated within the Comcast BNOC as follows: Supervisor at the end of the standard interval plus one hour; to the Manager at the end of the standard interval plus two hours, and to the Director at the end of the standard interval plus four hours.
Comcast’s standard maintenance window is Sunday to Saturday from 12:00am to 6:00am local time. Scheduled maintenance is performed during the maintenance window and will be coordinated between Comcast and the customer. Comcast provides a minimum of forty-eight (48) hour notice for non-service impacting scheduled maintenance. Comcast provides a minimum of seven (7) days notice for service impacting planned maintenance. Emergency maintenance is performed as needed.
Section 3 - Service Level Objectives
Availability is a measurement of the percentage of total time that the service is operational when measured over a 30 day period. Service is considered “inoperative” when either of the following occurs: (i) there is a total loss of signal for the service, (ii) output signal presented to the customer by Comcast does not conform to the technical specifications in Section 1.
3.2 Mean Time to Respond
Mean Time to Respond is the average time required for the BNOC to begin troubleshooting a reported fault. The Mean Time to Respond objective is fifteen (15) minutes upon receipt of a fault notification or from the time a trouble ticket is opened with the BNOC.
3.3 Mean Time to Restore
Mean Time to Restore is the average time required to restore service to an operational condition as defined by the technical specifications in Section 1 of this document. The Mean Time to Restore objective is four (4) hours for electronic equipment failure or six (6) hours for fiber optic facilities failure from the time a trouble ticket is opened with the BNOC.
Section 4 - Customer Responsibilities
Customers have the following responsibilities related to the installation, support, and maintenance of the Service.
4.1 Provide an operating environment with temperatures not below fifty-five (55) or above eighty-five (85) degrees Fahrenheit. Humidity shall not exceed ninety (90) percent at eighty-five (85) degrees Fahrenheit.
4.2 Provide secure space sufficient for access to one (1) standard, freestanding, equipment cabinet at each of the customer facilities, no further than fifty feet from the customer router or switch interface.
4.3 Provide outside cable entry conduit(s), entry cable ground point, and internal building conduit to allow Comcast the ability to rod/rope a fiber optic cable to the point of demarcation.
4.4 Locate and mark all private underground utilities (Water, Electric, etc.) along path of new underground placement not covered by utility companies.
4.5 Provide a pull rope in any existing duct that Comcast is to use and ensure existing duct is serviceable for Comcast use.
4.6 Obtain ‘right-of-way’ entry easement for Comcast facilities and equipment from property owners at each customer location.
4.7 The customer is responsible for coring of the building’s outside wall and internal walls. Upon request, Comcast can perform this activity on an ‘as needed’ basis for an additional one-time fee.
4.8 Provide UPS AC power equipment, circuit sizing to be determined, if applicable.
4.9 Emergency local generator backup service, if applicable.
4.10 Provide access to the buildings and point of demarcation at each customer location to allow Comcast and its approved Contractors to install fiber for service installation. Provide access to each location for regular (8am - 5pm) and emergency (24 hour) service and maintenance of Comcast’s equipment and facilities.
4.11 Provide, install and maintain a device that is capable of routing network traffic between the Service and the customer’s Local Area Network (LAN).
4.12 Customer must provide a point of contact for installation, service activation, and any maintenance activities.
Section 5 - Comcast BGP Policy
5.1 Customers must be multi-homed to run BGP, either:
a. multi-homed within Comcast’s network
b. multi-homed with Comcast and another service provider
5.2 Customers must use an Autonomous System (AS) number assigned by a regional registrar American Registry for Internet Numbers (ARIN), Réseaux IP Européens (RIPE), or Asia Pacific Network Information Centre (APNIC) etc. that is registered to their organization.
a. All customer route announcements must be registered with a regional registrar. A route object must exist for each route prefix in one of the well known global routing registries such as RADB.
b. The customer ASN needs to be verifiable in WHOIS database.
c. Comcast will only accept private peering when the customer is multi-homed to Comcast only.
d. Comcast will support a 4-byte ASN starting 01/01/2010 in accordance with ARIN policy.
e. Comcast will assign a private ASN in the range of 64512-65534 for private peering and not accept any customer provided private ASN.
f. Comcast will strip off the private ASN when advertising to peers.
5.3 Customers must use a router that supports BGPv4.
a. Comcast will not run BGP4 with customers connected on a link with less than 2Mbps bandwidth.
b. Customers are responsible to ensure their peering routers have adequate CPE processing power and memory space if a full Internet table is requested.
c. Comcast will employ all best-known practices to establish, maintain, and troubleshoot BGP4 sessions with all BGP4 compliant router vendors. However, Comcast makes no warranty that it can establish and maintain a BGP4 session with any CPE due to vendor interoperability.
5.4 Customers can specify one of the following received-prefixes options:
a. Default-route only
b. Comcast customer routes
c. Comcast customer routes + default-route
d. Full routes
e. Full routes + default-route
5.5 Customer must be capable of configuring their BGP session with Comcast. This includes all setup of neighbor statements and all sanity checks on customer CPE.
5.6 Comcast requests the use of an MD5 authentication key for all EBGP sessions. The customer should specify the MD5 password.
5.7 Customers must prevent redistribution from their Interior Routing Protocol (IRP) into BGP. Customers should also apply restrictive filters on outbound announcements so that only the customer’s intended outbound prefixes are announced to Comcast.
5.8 Comcast will assign a /30 IP address for the interfaces that connect to Comcast’s network. This will be assigned from a Comcast address block publicly registered with ARIN and already advertised as part of a larger aggregate to the Internet.
5.9 Comcast will announce any portable or non-portable net block so long as this space is larger than /24, and the space is assigned to the customer via WHOIS or RWHOIS databases. If the net block does not belong to the customer and the net block is not already being announced from the customer’s AS then Comcast will need to have an LOA (Letter of Agreement) from the true owner of the block stating that they are aware of, and are accepting of the fact that our customer wants to make the announcement through Comcast.
5.10 Comcast does not alter any of its BGP4 configurations, including route-maps, filter-policies, and communities, for any individual customer, but rather will dynamically alter BGP policy dependent on the customers’ employment of predefined Comcast BGP communities. This ensures the Comcast network is built and maintained in a strategic, organized, and efficient fashion and reduces mean-time-to-repair for BGP related trouble.